How locks work
Where the water goes
A lock is a bath with a door at each end. Everything else is detail, but the detail is what you watch for twenty minutes on a Sunday afternoon.
1. Gates shut, water high
A boat going down enters the full lock. Both sets of gates are shut and the water level matches the pound above.
2. Paddles open
The crew wind up the bottom paddles with a windlass. Water rushes out through the culverts and the level in the chamber starts to fall.
3. Levels equal
When the chamber matches the lower pound, the water stops moving. The gates will not open before this: the pressure holds them shut.
4. Gates open
Push the balance beams and the mitre gates swing back into their recesses. The boat leaves, the gates are closed again, and the lock is ready for the next one.
Why the gates point uphill
Mitre gates meet at an angle that points towards the higher water. The pressure of the water pushes the two leaves together and seals them, which is why you cannot open a gate until the levels are equal, however hard you push. It is also why a lock cannot be opened at both ends at once: a whole pound could drain through it.
Staircases and flights
A flight is a run of separate locks with short pounds between them. A staircase joins the chambers directly, so the top gate of one lock is the bottom gate of the next. Staircases are quicker to build and slower to think about: fill the wrong chamber first and you flood the towpath. That is why the busiest ones have a lock-keeper.